15228 Autoloader ALE: Has plate been removed from Drum ? 'Resume'= Yes -*- 'Clear' = No Platesetter_3244 Thermal only. This will be reported if an attempt was made to load a plate while there was still a plate on the drum. If there is infact no plate on the drum then select "resume" otherwise select "clear" To remove a plate from the drum consult operator manual or operator training notes. resume sets plate_loc D status to 0 (empty). Clear abandons the load attempt. Thermal only. This will be reported if an attempt was made to load a plate while there was still a plate on the drum. ../commands/getclamp.xmlCommand: getclamp ../nvs/plate_loc_state_General_syntax_PS3244.xmlNVS: plate_loc General_syntax_PS3244 ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:58 2008 PST